StoneTech® Professional Honing Powder
StoneTech® Professional Honing Powder Features and Benefits: • Creates honed finishes • Sets up stone for polishing and shining • Different grits eliminate mild to deep scratches • Non-acidic Where to Use: Natural stone such as marble, limestone, travertine & terrazzo. Directions: Read entire label before using. Use only as directed. Always test in a small inconspicuous area to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings. 1. If surface is heavily soiled, preclean with StoneTech® Professional KlenzAll™ Cleaner if needed. 2. Mask any surfaces not intended to be treated. 3. If you are using a variety of abrasive grits, ensure that the surface is well rinsed and a new pad is used for each changeover. 4. Apply approximately 1/2 cup Honing Powder plus 1 cup clean water to stone surface. 5. Refinish using a hand orbital sander or weighted floor machine at 130-140 lbs., 175 rpm, fitted with a natural hair pad. 6. Keep compound wet while refinishing with plenty of water. Add Honing Powder as needed. 7. Refinish area until the desired level of hone has been achieved. 8. Rinse well and use a wet vacuum or hot water extraction unit to remove all remaining compound. 9. Clean equipment with water. Use successively higher grits of Honing Powder to close the face of the stone and follow with StoneTech® Professional Polishing Powder and StoneTech® Professional Shining Powder as applicable. Coverage: 180 Grit approximately 1,000-2,000 sq. ft. per pound
Copyright © 2020; The Mop Bucket. All Rights Reserved.